Common Faults and Solutions of Weighing Instruments

Introduction

Weighing equipment is a high-tech equipment, can dynamically detect the production line packaging links of various quality problems, can reduce labor costs for manufacturing enterprises, thus improving the efficiency of production lines. Weighing equipment, on the other hand, is a vital part of the equipment, it is to display the weighing data for users to check, but also the key to determine whether the equipment is operating properly. What’s more, important parts of the equipment, in the use must do a good job of maintenance work, for weighing equipment weighing instrument common faults should also have a certain understanding. 

High Precision Electronic Blue Tooth Bench Scale

Fault phenomenon: Large screen display does not display normal weighing data from boot.  

Cause of failure: The connection mode between the weighing display interface and the large screen interface is not uniform.

Solutions：Find some of the contents of the connection interface in this weighing display manual and large screen description, and the correct connection to the interface is normal.

Fault phenomenon：After weighing the monitor and computer connection, run the weighing software without weighing digital display.

Cause of failure：The data cable connection between the weighing display and the computer is incorrect or the baud rate setting is not uniform.

Solutions：Find some of the contents of this weighing display manual and large screen description about the weighing display and computer connection interface, connect the interface correctly, and then check the weighing display and computer software baud rate settings.

Fault phenomenon：The boot displays a "ERR" error message, while the weighing display checks each sensor in the modified address state, and the sensor works correctly. And from "No. 1th" began to gradually increase the number of connected sensors, received a certain number of not all sensors are connected, the weighing display appears a "ERR" error message. 

Cause of failure：Weighing displays do not have enough power to load.

Solutions：Replace the weighing display.